![]() Not maintained by MongoDB and conflict with MongoDB’s officallyīut, this seems to be an outdated answer which explains when I tried to do mongodump using the installed mongodb with that approach, it did not work.Īfter using the Outdated approach, this the installed mongodb info. This is the unofficial mongodb package provided by Ubuntu and it is I looked it up all over the internet and I couldn’t find any solution even though it has been asked several times Īfter doing some research, I have found this stackoverflow question where most answers say that I should just:Īt first try with this command: sudo apt-get install -y mongodb ![]() You should check the MongoDB logs and Windows Event Viewer to find the reason your service is unable to start. The solution would be to fix your MongoDB installation for it to start and re-install WFFM after. MongoDB has been successfully configured. The MongoDB pops up with a message The MongoDb Service was started successfully. Step 12: Again type the command: net start mongoDb. STEP 4: sudo apt-get install -y mongodb-org As you experienced, the installation wizard spins forever when MongoDB is not started and the package does not install. Step 11: Open Command prompt with admin privileges and write this command: mongod config C: datamongod.cfg install. STEP 2: echo "deb xenial/mongodb-org/5.0 multiverse" | sudo tee /etc/apt//mongodb-org-5.0.list I have been trying to install mongodb following the official documentation.
0 Comments
Leave a Reply. |